n features l 2 form c small size,surface mounting relay. l super miniature size: 0.2 inch 0.1 inch grid, 12 pin dip up to 50% less volume and board area than previous generation telecom relay. l ul, csa recognized. l high dielectric and surge strength: 2.5 kv surge (per bellcore ta-nwt-001089) 1.5 kv surge (per fcc part 68) 1,000 vrms, open contacts l low power consumption: 80 mw operate 140 mw nominal l tape and reel packing for automatic mounting. (a) series name fbr18 : fbr18 series [2 pole double throw (2 form c)] (b) enclosure n : plastic sealed (washable type) (c) coil type d : dc coil (d) nominal voltage refer to the coil data chart (e) contact material nil : gold-overlay silver-nickel Cp : gold-overlay silver-palladium (f) terminal nil : standard Cm : high density mounting (g) custom designation to be assigned custom specification (h) csa standard Ccsa: ul114 + csa recognized (i) packing nil : tape and reel (500 pieces/tape and reel) note: the designation name is stamped on the top of the relay case as follows: (example) designation ordered : fbr18nd05 stamp : 18nd05 fbr18 series miniature relay (surface mount type) 2 poles1 to 2 a (for signal switching) n safety standard and file numbers ul508, 1950, 114 (file no. e63615) c22.2 no. 0, no. 14 (file no. lr40304 or lr64026) nominal voltage contact rating 2 a 30 vdc resistive 3 to 24 vdc 0.3 a 110 vdc resistive 0.5 a 125 vac resistive n ordering information fbr18 n d 12 Cp Cm C ** (Ccsa) C n n [example] (a) (b) (c) (d) (e) (f ) (g) (h) (i) not for new designs fbr18nd/hd to be discontinied - except fbr18wd
2 fbr18 series not for new designs fbr18nd/hd to be discontinied - except fbr18wd n specifications item standard (gold-overlay silver-nickel) -p type (gold-overlay silver-palladium) contact arrangement 2 form c (dpdt) material gold-overlay silver-nickel gold-overlay silver-palladium style bifurcated resistance (initial) maximum 100 m w (at 0.1 a 6 vdc) rating (resistive) 0.5 a 125 vac or 1 a 30 vdc maximum carrying current 2 a (at 20 c) maximum switching power 62.5 va or 60 w max. switching voltage* 1 250 vac or 220 vdc maximum switching current 2 a minimum switching load* 2 0.01 ma 10 mvdc (reference) capacitance approximately 1.0 pf (between open contacts, adjacent contacts ) (at 10 khz) approximately 1.0 pf (between coil and contacts) coil nominal power (at 20 c) approximately 0.14 w (0.2 w for 24 v coil) operate power (at 20 c) maximum 0.08 w (0.112 w for 24 v coil) thermal resistance at approximately 115 c/w continuous thermal load operating temperature C40 c to +85 c (no frost) (refer to the characteristic data) operating humidity 45 to 85%rh time value operate (at nominal voltage) maximum 4 msec. release (at nominal voltage) maximum 4 msec. max. switching frequency mechanical 3 hz or electrical 0.5 hz (at contact rating) insulation resistance (initial) minimum 1,000 m w (at 500 vdc) dielectric between open contacts 1,000 vac strength adjacent contacts 1 minimum between coil and contacts 1,500 vac 1 minimum surge between open 1,500 v strength contacts, (at 10 700 m s) adjacent contact between coil and contacts 2,500 v (at 2 10 m s) life mechanical 1 10 8 operations minimum electrical dc 2 10 5 operations minimum 5 10 5 operations minimum (at contact rating) ac 1 10 5 operations minimum 2 10 5 operations minimum other vibration misoperation 10 to 55 hz (double amplitude of 1.5 mm) resistance endurance 10 to 55 hz (double amplitude of 3.0 mm) shock misoperation 500 m/s 2 (11 1 ms) resistance endurance 1,000 m/s 2 (11 1 ms) weight approximately 1.9 g * 1 if the switching voltage exceeds the rated contact voltage, reduce the current. the current values vary according to the type of load. * 2 values when switching a resistive load at normal room temperature and humidity and in a clean atmosphere. the mini- mum switching load varies with the switching frequency and operation environment. 1,500 750 10 700 2,500 1,250 210
3 fbr18 series not for new designs fbr18nd/hd to be discontinied - except fbr18wd model nominal nominal coil current must must nominal operate coil resistance (at nominal operate release temperature voltage ( 10%) voltage) voltage* 1 voltage* 1 power power rise standard -p type approx. fbr18nd03 fbr18nd03-p 3 vdc 64.3 w 46 ma fbr18nd04 fbr18nd04-p 4.5 vdc 145 w 31 ma fbr18nd05 fbr18nd05-p 5 vdc 178 w 28 ma 75% max. 10% min. approx. approx. approx. of nominal of nominal 0.14 w 0.08 w 20 deg fbr18nd06 fbr18nd06-p 6 vdc 257 w 23 ma (at nominal (at nominal voltage voltage voltage) max. voltage) fbr18nd09 fbr18nd09-p 9 vdc 579 w 15 ma fbr18nd12 fbr18nd12-p 12 vdc 1,028 w 11 ma fbr18nd24 fbr18nd24-p 24 vdc 2,880 w 8 ma 0.2 w 0.112 w 30 deg n coil data chart *1: specified values are subject to pulse wave voltage. note: all values in the table are measured at 20 c. n characteristic data life curve 500 contact load current (a) 50 5 10 1 100 (x10 4 ) service life (operations) 0.5 1.0 1.5 2.0 maximum switching capacity contact load voltage (v) 0.1 10 20 125 200 30 50 0.2 0.3 0.5 1.0 2.0 range of operation temperature and voltage operating temperature (?c) 100 1020304050607080 70 80 90 100 110 120 130 140 150 160 ac resistive load ( ac contact rating) dc resistive load ( dc contact rating) operating voltage range must operate voltage maximum allowable coil voltage (data) assumes that the maximum allow- able temperature of e type insulation coil is 115?c contact load current (a) nominal voltage multiplying ffactor (%) (?)type (?)type 30 v dc resistive load 125 v ac resistive load model nominal coil must must nominal operate coil resistance operate release temperature voltage ( 10%) voltage* 1 voltage* 1 power power rise standard -p type fbr18wd03 fbr18wd03-p 3 vdc 39 w fbr18wd04 fbr18wd04-p 4.5 vdc 88 w fbr18wd05 fbr18wd05-p 5 vdc 108 w 75% max. 10% min. approx. approx. approx. of nominal of nominal 0.23 w 0.13 w 30 deg FBR18WD06 FBR18WD06-p 6 vdc 156 w (at nominal (at nominal voltage voltage voltage) max. voltage) fbr18wd09 fbr18wd09-p 9 vdc 352 w fbr18wd12 fbr18wd12-p 12 vdc 626 w fbr18wd24 fbr18wd24-p 24 vdc 2,304 w 0.25 w 0.14w 33 deg *1: specified values are subject to pulse wave voltage. note: all values in the table are measured at 20 c. fbr-18 w type fbr-18 n type
4 fbr18 series not for new designs fbr18nd/hd to be discontinied - except fbr18wd n dimensions unit: mm l dimensions l schematics (top view) l pc board mounting pad layout (top view) standard (fbr18 type) high density mounting (fbr18-m type) 14.7 +0.3 10.15 +0.2 7.02 2.73 7.4 +0.1 8.9 +0.1 5.08 5.08 (1.0) 1.45 2.54 2.54 + 1345 12 10 9 8 5.08 2.54 2.54 1 14.7 +0.3 10.35 +0.2 6.49 2.2 7.4 +0.1 7.4 +0.1 5.08 0.25 5.08 1.65 2.54 2.54 + 1345 12 10 9 8 5.08 2.54 2.54 1 (1.0) 0.25 n reference data operate release distribution of operate and release voltage rated coil voltage multiplying factor (%) 60 50 40 20 30 10 01020 304050 607080 0 distribution (%) operate release distribution of operate and release time time (ms) 100 80 60 20 40 012 34 5 6 7 8 0 contact resistance (m ) distribution of contact resistance 80 60 40 20 01020 304050 607080 0 distribution (%) distribution (%)
5 fbr18 series not for new designs fbr18nd/hd to be discontinied - except fbr18wd n packing (1) quantity of 1 reel : 500 pieces ? packing orientation code: b (2) dimensions (in mm) ? reel dimensions ? tape dimensions note: relays are sold in packs of 500 pieces, please order 500 pieces as 1 unit. feeding orientation mark side irs (infrared reflow soldering) t 3 t 2 t 1 t 3 = 245 c max. t 2 = 200 c max. t 1 = 165 c max. 0 temperature ( c) soldering preheating cooling 120 sec maximum 30 sec max. vps (vapor phase soldering) t 3 t 2 t 1 t 3 = 200 c maximum t 2 = 165 c maximum t 1 = 100 c maximum 0 temperature ( c) soldering preheating cooling 90 sec max. 60 sec max. 60 sec max. 215 c maximum n recommended soldering conditions (temperature profile) note: 1.temperature profiles show the temperature of pc board surface. 2.please perform soldering test with your actual pc board before mass production, since the temperatures of pc board surfaces vary according to the size of pc board, status of parts mounting and heating method.
6 fbr18 series not for new designs fbr18nd/hd to be discontinied - except fbr18wd ? 2001 fujitsu components america, inc. all company and product names are trademarks or registered trademarks of their respective owners. rev. 09/2001 japan fujitsu component limited gotanda-chuo building 3-5, higashigotanda 2-chome, shinagawa-ku tokyo 141, japan tel: (81-3) 5449-7010 fax: (81-3) 5449-2626 email: promothq@ft.ed.fujitsu.com web: www.fcl.fujitsu.com north and south america fujitsu components america, inc. 250 e. caribbean drive sunnyvale, ca 94089 u.s.a. tel: (1-408) 745-4900 fax: (1-408) 745-4970 email: marcom@fcai.fujitsu.com web: www.fcai.fujitsu.com europe fujitsu components europe b.v. diamantlaan 25 2132 wv hoofddorp netherlands tel: (31-23) 5560910 fax: (31-23) 5560950 email: info.marketing@fceu.fujitsu.com web: www.fceu.fujitsu.com asia pacific fujitsu components asia ltd. 102e pasir panjang road #04-01 citilink warehouse complex singapore 118529 tel: (65) 375-8560 fax: (65) 273-3021 email: fcal@fcal.fujitsu.com www.fcal.fujitsu.com fujitsu components international headquarter offices
|
